Results 1 to 7 of 7

Thread: Bolt on wheels to quick release wheels

  1. #1

    Bolt on wheels to quick release wheels

    I have a wheelchair that i use occasionally that has the bolt on wheels. This is not my main chair but one I use outdoors and on certain trips. I have been trying to find out if i can add quick release wheels to this chair? If so how?

  2. #2
    What do you mean by 'bolt on'?

  3. #3
    What brand and model of chair?

  4. #4
    Its a cheap drive chair i got from amazon

  5. #5
    Here is the axle mounting setup as used by Quickie for folders, others are similiar. If you can figure out how to mount part #1 on your chair, then yes you could go to quick release. Parts are probably available for next to nothing or free here except getting the axle length correct is always a little harder. The axle plates are about 3"X5" and must be mounted parallel to each other or such as to provide wheel camber.
    Attached Images Attached Images  
    I have had periodic paralysis all my life. I lost my ability to walk in 2011 beginning with a spinal block, which was used for a hip fracture caused by periodic paralysis.

  6. #6
    Thank you so much

  7. #7
    Try taking the wheel mounting bolt out. See what diameter it is. Probably 1/2 or 7/16 inch. If its 1/2 inch try sticking a quick release pin in and see if it works. Might have to hunt for the right length.

Similar Threads

  1. Replies: 2
    Last Post: 07-09-2017, 01:50 PM
  2. Replies: 3
    Last Post: 11-11-2013, 07:14 PM
  3. Replies: 24
    Last Post: 06-16-2013, 06:57 PM
  4. wanted 24'' quickie quick release wheels
    By jenjen138 in forum Equipment & Services
    Replies: 0
    Last Post: 12-31-2011, 06:44 PM
  5. Replies: 0
    Last Post: 05-22-2009, 03:33 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •