Search:

Type: Posts; User: Rustyjames

Page 1 of 77 1 2 3 4

Search: Search took 0.10 seconds; generated 17 minute(s) ago.

  1. I have a vertical platform lift to access my...

    I have a vertical platform lift to access my basement. I bought it used but it was only a few months old and in like new condition. They can be bought pretty cheap if you search around and are not...
  2. Whatever. Around here we have basements,...

    Whatever. Around here we have basements, predominately. I am in a wheelchair and have a basement. If I was going to build a new house (here in NJ) it would have a basement. Slab on grade is big...
  3. @vjs: Yes, FL has high water table, don't know...

    @vjs: Yes, FL has high water table, don't know about GA, although there's clay which is pretty much impermeable. Also freeze/thaw cycles make it necessary for a foundation, not a big of an issue in...
  4. Because it adds value, makes plumbing, electrical...

    Because it adds value, makes plumbing, electrical and HVAC systems easier to install/maintain. It's also a handy place to go when natural disasters occur.
  5. Some areas of the country, like NJ, just about...

    Some areas of the country, like NJ, just about every house has a basement.
  6. I didn't miss the point, just saying that Salt...

    I didn't miss the point, just saying that Salt Water can do a number on any electronics. Big difference riding in the rain (fresh water) than being exposed to salt water.
  7. Salt water around a powerchair is never a good...

    Salt water around a powerchair is never a good idea, you're really pushing the parameters of intended use.
  8. Replies
    21
    Views
    791

    Holding the inner race and spinning the out race...

    Holding the inner race and spinning the out race the bearing should spin freely, should be no resistance. There should be a sleeve between the two bearings, if that's missing, or too short the...
  9. Bearings are sealed, they should be fine.

    Bearings are sealed, they should be fine.
  10. If I had to guess I'd say Europe, that paver...

    If I had to guess I'd say Europe, that paver stagger is common in Germany. Here is typically a half running bond.
  11. Does your Daughter have a spinal cord injury? If...

    Does your Daughter have a spinal cord injury? If so then tilt will probably be a necessity from your discription. Elevation is always nice to have but I don't think all insurances will cover that. ...
  12. Thread: 2 batteries

    by Rustyjames
    Replies
    8
    Views
    659

    Could be something draining the battery(s). ...

    Could be something draining the battery(s). Might not even be battery related, could be a defective relay or starter.
  13. I think the intent is to make it user friendly...

    I think the intent is to make it user friendly for AB as well as wheelchair users, with aesthetics in mind. Handrails or bumpers would be a "barrier" to the AB's. But agreed, it could be dangerous...
  14. Replies
    14
    Views
    934

    Another method that works well is to lean over...

    Another method that works well is to lean over the side of the chair, a minute or so on each side. But you need full arm rests to lean on, otherwise it could be unsafe.
  15. Replies
    14
    Views
    934

    I don't do timed weight shifts, but I'm...

    I don't do timed weight shifts, but I'm constantly lifting my butt (on varying sides) momentarily to help relieve my nerve pain. But I primarily use a powerchair which makes that easier.
  16. Replies
    13
    Views
    938

    "He said that the plan that we had would not work...

    "He said that the plan that we had would not work and came up with an alternative plan, but he said the new plan doesn't actually follow the rules either. He said that it was OK though because he...
  17. Replies
    13
    Views
    938

    If you use a powerchair you could go steeper than...

    If you use a powerchair you could go steeper than the ADA minimum requirement. If you use a manual then longer runs to rise is better.
    It sounds like the building inspector is willing to work...
  18. That's a great resource, thank you for positing...

    That's a great resource, thank you for positing it.
  19. Replies
    13
    Views
    938

    In most jurisdictions there's a lot of leeway...

    In most jurisdictions there's a lot of leeway given to residential access situations. That often includes setbacks, ramp rise/run, etc. I would just ask the building inspector, he/she should be...
  20. Replies
    10
    Views
    503

    You'd have to remove the spreader bar and use a...

    You'd have to remove the spreader bar and use a shackle to make those connections. Or leave the spreader on and rig up some nylon straps to hang the scale. You probably wouldn't be able to use the...
  21. Replies
    10
    Views
    503

    This thread might be helpful:...

    This thread might be helpful: http://sci.rutgers.edu/forum/showthread.php?264357-Are-there-scales-that-can-be-attached-to-a-overhead-lift&highlight=Digital+scale
  22. Replies
    4
    Views
    399

    Might have to remove the wheel to get at it.

    Might have to remove the wheel to get at it.
  23. Replies
    14
    Views
    924

    So, the 10 way seat was factory installed? I...

    So, the 10 way seat was factory installed? I agree with your thoughts about the work performed, especially considering the amount of money you paid and the time it took. Did the install include a...
  24. Replies
    14
    Views
    924

    I can relate to your experiences getting work...

    I can relate to your experiences getting work done. Doesn't look that bad, you could have a trim piece made of some bent aluminum to give it a more finished look. I would imagine all those lifts...
  25. Replies
    1
    Views
    218

    My panel is exactly the same in my shop, I can...

    My panel is exactly the same in my shop, I can easily access the breakers. I was fortunate that the panel was already placed like that when I bought my place. Nice garage, BTW.
Results 1 to 25 of 1914
Page 1 of 77 1 2 3 4