Search:

Type: Posts; User: coolmobility

Page 1 of 2 1 2

Search: Search took 0.01 seconds.

  1. Replies
    761
    Views
    221,585

    I'd agree with Pat, the bracket to mount the...

    I'd agree with Pat, the bracket to mount the second controller must be solid. Consider using a 25mm clamshell yacht tube clamp like this...
  2. Replies
    761
    Views
    221,585

    The big fluted box on top of the batteries is the...

    The big fluted box on top of the batteries is the VR2 central controller, but the smooth small (about 3" square) box, usually located on top of that, is the Lithium Battery Management System (BMS)...
  3. Replies
    761
    Views
    221,585

    Yesterday, after having my reprogrammed ZX-1 for...

    Yesterday, after having my reprogrammed ZX-1 for over a year, I finally took it for a run with a hand-held GPS to measure speed.

    On full, 100% speed, on flat road I get 8.8 to 9kph. Even down a...
  4. Replies
    761
    Views
    221,585

    Hi, all my initial changes were made by a basic...

    Hi, all my initial changes were made by a basic programmer and then later, a more advanced touch screen one with program USB plug for installing new Lithium program (that had not been installed on my...
  5. Replies
    761
    Views
    221,585

    Full charge from flat is about 4 hours and with...

    Full charge from flat is about 4 hours and with the limited range, carrying the charger on long trips may be useful. Stop for lunch by a power point for a charge boost would make a big difference as...
  6. Replies
    761
    Views
    221,585

    Sorry about your problems Charlie89, hope it is...

    Sorry about your problems Charlie89, hope it is fixed soon and enjoy your holiday. Charllie, what country are you from, as it helps with advice on the forum? Your dealer would be able to get...
  7. Replies
    761
    Views
    221,585

    I too swapped the elastomer Frogleg with the one...

    I too swapped the elastomer Frogleg with the one having an alloy block instead, and I think ride is better too. Raised rear axle to give better clearance on motors as I have the larger knobby main...
  8. Replies
    761
    Views
    221,585

    PMs don't seem to be working. I've tried to PM...

    PMs don't seem to be working. I've tried to PM twice but no Sent PM after submitting.
  9. Replies
    761
    Views
    221,585

    Welcome Charlotte. Yes, you can have the top...

    Welcome Charlotte. Yes, you can have the top speed increased, provided you can handle the balance and reaction issues, and take care at the higher speed. Your dealer should be able to do this for you...
  10. Replies
    761
    Views
    221,585

    I almost ran out of battery power today as when I...

    I almost ran out of battery power today as when I took off to the yacht club to go sailing. My battery lights were decreasing too quickly (I have LiIon batteries) and I thought something was wrong as...
  11. Replies
    761
    Views
    221,585

    I too travel with my left arm hooked over the...

    I too travel with my left arm hooked over the back when descending steep ramps like to my yacht club floating pontoon or over rough terrain better to be safe than sorry. I've had a front wheel drop...
  12. Replies
    761
    Views
    221,585

    Hi robotnik, Glad the settings work well for you...

    Hi robotnik, Glad the settings work well for you too. In speed profile 4 & 5 the acceleration is very slow, as is the torque, so it won't start on a hill or turn when stopped. This is on purpose as...
  13. Replies
    761
    Views
    221,585

    Spinergy Customer Service

    When I started complaining, Spinergy assured the local agent my program was right. After numerous emails, they then conceded that my controller possibly had the wrong programming, but claimed their...
  14. Replies
    761
    Views
    221,585

    I have a Lithium version and had the same...

    I have a Lithium version and had the same problem. Your dealer needs to install a new internal program in your controller from a USB, not just profiles for speeds.
    I weigh 90kg and have speed 5 at...
  15. Replies
    761
    Views
    221,585

    Expect nothing and you won't be disappointed. No,...

    Expect nothing and you won't be disappointed. No, really, with two motors of this Wattage size, batteries of only 24V @ 15Ah, you can't expect a large range. Wheelchair testing is done with the ANSI...
  16. Replies
    761
    Views
    221,585

    I got the silicone strips that are supposed to...

    I got the silicone strips that are supposed to stop sideways sliding of clamp on axle tube. No instructions as to how they are supposed to be applied, so Spynergy sent me these photos (through my...
  17. Replies
    761
    Views
    221,585

    I've had that manual for a month (used to sort...

    I've had that manual for a month (used to sort out problem) and asked Spynergy if I could post here but they wanted it on their new website. Well worth a look. I suggested some edits to the manual,...
  18. Replies
    761
    Views
    221,585

    Beware increasing voltage applied to a brushless...

    Beware increasing voltage applied to a brushless system. The motor may be fine, but the controllers are built for specific voltage ranges and increasing voltage may blow the controller components...
  19. Replies
    761
    Views
    221,585

    Lithium Manganese are not as safe/stable as...

    Lithium Manganese are not as safe/stable as LiFePO4 cells (can burst into flames if shorted) and have a much more limited life of recharges. You would need to use a dedicated charger plugged straight...
  20. Replies
    761
    Views
    221,585

    Interestingly, I have obtained a copy of the...

    Interestingly, I have obtained a copy of the "ZX-1 Field Adjustment Manual REV1 1152015 FINAL", which I hope to obtain permission to post here. The new system of the lower bolt adjustment has changed...
  21. Replies
    761
    Views
    221,585

    AGM is Adsorbed Glass Matt where each lead plate...

    AGM is Adsorbed Glass Matt where each lead plate of a SLA battery is prevented from touching by a layer of usually fibreglass matt. Your SLA battery would most likely be an AGM.

    For the crimps you...
  22. Replies
    761
    Views
    221,585

    Those voltage readings are somehow all too high...

    Those voltage readings are somehow all too high for AGM batteries.

    Resting State of Charge (SOC) - (measured off charger for at least 10 minutes) should be more like below for an AGM battery. Only...
  23. Replies
    761
    Views
    221,585

    Well, those voltage readings in that condition...

    Well, those voltage readings in that condition indicate the batteries are fine, charger is connecting and charging, and there is no short in the controller system (in normal use) - that's good.
    ...
  24. Replies
    761
    Views
    221,585

    First thing is check that all the plugs into the...

    First thing is check that all the plugs into the Controller are plugged in solid as they vibrate loose easily. On my new one, the biggest major plug was out about 1/8" - still in contact and driving...
  25. Replies
    761
    Views
    221,585

    Checking battery voltage drop with load applied,...

    Checking battery voltage drop with load applied, will show ALL the time, if it is a problem, not just some times. If only at occasional times, it is likely to be a poor battery connector, which could...
Results 1 to 25 of 34
Page 1 of 2 1 2