Tab Content
  • Brad09's Avatar
    09-13-2018, 08:55 AM
    Yes it is the titanium satin finish. It gets scratched just as easy as any other finish, but the scratches are the same color as the frame just...
    47 replies | 43734 view(s)
  • Brad09's Avatar
    09-10-2018, 08:44 AM
    The Ride Java eliminates all of the transfer issues mentioned, while still holding your hips in place and floating your ischials. Although it isn't a...
    16 replies | 1195 view(s)
  • Brad09's Avatar
    09-07-2018, 09:03 AM
    Yea, the Ride custom 2 is way different than the Java I have. I can see how that one would sit you up a lot higher. You could cut a whole lot more...
    16 replies | 1195 view(s)
  • Brad09's Avatar
    08-31-2018, 02:19 PM
    The cushion bends with the ergo frame, I use a Ride Java cushion. I can't feel a difference with the ergo frame, but they are supposed to help keep...
    22 replies | 1343 view(s)
  • Brad09's Avatar
    08-30-2018, 04:43 PM
    Brad09 replied to a thread New Chair Opinions in Equipment
    Just out of curiosity, why do you like 4 degrees of camber? I don't know that many cushions are 4" tall in the front, but even if you set it at 10"...
    6 replies | 1056 view(s)
  • Brad09's Avatar
    08-30-2018, 04:33 PM
    Brad09 replied to a thread Right Run failure in Equipment
    I've had that happen before with right runs, try replacing the tube first.
    18 replies | 1797 view(s)
  • Brad09's Avatar
    08-30-2018, 04:05 PM
    Brad09 replied to a thread New Chair Opinions in Equipment
    Its hard to give advice on measurements like seat to floor heights, frame length, footplate height, etc. online as opposed to being in person since...
    6 replies | 1056 view(s)
  • Brad09's Avatar
    08-30-2018, 02:35 PM
    I know I'm late on this since you've already been (and I've only driven to the beach, not flown), but for anyone else's benefit I take an extra pair...
    6 replies | 1141 view(s)
  • Brad09's Avatar
    08-30-2018, 11:50 AM
    Although our body types are way different (I'm 6'-2 with a T6 SCI) this is an example of an extended frame depth (1.5" I think). This gives me plenty...
    22 replies | 1343 view(s)
  • Brad09's Avatar
    08-30-2018, 09:07 AM
    Brad09 replied to a thread An Alternative to Tilite in Equipment
    I'm not sure what the fact that tilite has made millions of chairs over 20 years has to do with the quality of their currents ones going downhill....
    33 replies | 2824 view(s)
  • Brad09's Avatar
    08-29-2018, 04:54 PM
    For what it's worth, I have no connection with Indemedical. But I do get most of my supplies from them. They usually have the lowest price on the...
    24 replies | 1190 view(s)
  • Brad09's Avatar
    08-28-2018, 04:55 PM
    I had one of these handsaws laying around that helped a lot (much easier than using a knife) since it is so long. It's going to be really hard to get...
    16 replies | 1195 view(s)
  • Brad09's Avatar
    08-28-2018, 04:01 PM
    After all you've lost physically and had to endure emotionally...after all of the pain, suffering, and depression that comes from dreams and goals...
    9 replies | 898 view(s)
  • Brad09's Avatar
    08-28-2018, 03:37 PM
    Brad09 replied to a thread An Alternative to Tilite in Equipment
    While I agree with all the statements about Tilite's customer service/workmanship going downhill since being acquired by Permobil, can an aluminum...
    33 replies | 2824 view(s)
  • Brad09's Avatar
    08-28-2018, 12:41 PM
    I think it's more important for your floor to seat height to be setup to maximize the efficiency of pushing your chair, rather than being able to...
    16 replies | 1195 view(s)
  • Brad09's Avatar
    08-27-2018, 12:59 PM
    Do you think if I cathed three times a day (every 8 hours about) and used the leg bag that it would be enough to avoid the issues you had with...
    14 replies | 894 view(s)
  • Brad09's Avatar
    08-27-2018, 10:42 AM
    I've been using surge handrims daily for four years now and aside from the typical knicks and scrapes they have never given any indication of peeling...
    4 replies | 476 view(s)
  • Brad09's Avatar
    08-27-2018, 08:57 AM
    Brad09 replied to a thread Ki Rogue take two in Equipment
    If you didn't start with the measurements from your ZR and adjust from there, where did they come from? It sounds like your biggest issue is your...
    17 replies | 2683 view(s)
  • Brad09's Avatar
    08-24-2018, 03:44 PM
    Thanks for the reply, I've tried Myrbetriq (and most other big name bladder meds over the years). While the side effects weren't as bad as other...
    14 replies | 894 view(s)
  • Brad09's Avatar
    08-24-2018, 02:36 PM
    Long story short, after many years I have stopped all bladder meds due to cognitive side effects that aren't worth it to me anymore. I still have...
    14 replies | 894 view(s)
  • Brad09's Avatar
    08-23-2018, 09:25 AM
    Under certain circumstances yes, because I've done it. I had to send my last TR3 frame back once to fix a screw up. After I finally got the 2nd...
    20 replies | 1443 view(s)
  • Brad09's Avatar
    08-22-2018, 08:32 AM
    Brad09 replied to a thread Other SCI forums in Life
    I think most people understand a lot of advice given on here may be unique to the individual giving it. While it may not apply to most people,...
    36 replies | 5806 view(s)
  • Brad09's Avatar
    08-20-2018, 10:48 AM
    Brad09 replied to a thread Other SCI forums in Life
    One reason I think this happens, and I'm guilty of it too, is that new members/injuries come here for answers. Most just browse, some ask questions....
    36 replies | 5806 view(s)
No More Results
About Brad09

Basic Information

About Brad09
Date of injury (NA if not spinal-injured)?:
2012
Gender:
Male
Biography:
T6 complete

Statistics


Total Posts
Total Posts
416
Posts Per Day
0.19
General Information
Last Activity
Today 11:55 AM
Current Activity
Viewing Thread For sale smart drive mx2
Join Date
11-04-2012
Referrals
0