Tab Content
cfx's Activity
About Me
Tab Content
  • cfx's Avatar
    Yesterday, 09:01 PM
    cfx replied to a thread Matrx elite in Equipment
    I sent you a pm, but I already patched it.
    8 replies | 241 view(s)
  • cfx's Avatar
    Yesterday, 08:55 PM
    cfx replied to a thread Matrx elite in Equipment
    Check around the welds first. I'm sure they cold weld these instead of preheating the aluminum.
    8 replies | 241 view(s)
  • cfx's Avatar
    06-18-2019, 01:21 PM
    THANKS!!!! Not too long found a mower with casters and just welded a sub frame to hold motors alternator and batterys. The drive controller is a...
    15 replies | 613 view(s)
  • cfx's Avatar
    06-18-2019, 01:12 PM
    cfx replied to a thread Matrx elite in Equipment
    I will be looking at a new chair soon and yes the back is aluminum. I'm not heavy at all and I don't do anything crazy since I'm higher level SCI....
    8 replies | 241 view(s)
  • cfx's Avatar
    06-18-2019, 11:57 AM
    cfx started a thread Matrx elite in Equipment
    And yet another back rest that cracked in multiple places. They only last 2-3 years before they crack. Between these and Roho's I keep just wasting...
    8 replies | 241 view(s)
  • cfx's Avatar
    06-18-2019, 11:50 AM
    This was the first run. I have dialed in the controls now much smoother. Also we have a lawn now.
    15 replies | 613 view(s)
  • cfx's Avatar
    06-12-2019, 09:17 PM
    I need to figure out an edger. I built a remote control lawn mower for the grass. It uses two invacare wheel chair motors and a 24v alternator to...
    15 replies | 613 view(s)
No More Results
About cfx

Basic Information

About cfx
Date of injury (NA if not spinal-injured)?:
1998 c7 fx 2011 T678 fx
Location:
ohio
Gender:
Male

Statistics


Total Posts
Total Posts
382
Posts Per Day
0.14
General Information
Last Activity
Yesterday 09:01 PM
Join Date
03-18-2012
Referrals
0